.
7
CHAPTER 3: SETUP & INSTALLATION
5
4. Connect the CAT5 cable to the transmitter.
5. Apply power on the transmitter. The LED should light and, if there’s a local
monitor attached, a video image should appear on the monitor’s screen.
At the receiver end:
1. Connect the VIDEO OUT HD15 connector to the display unit, and attach
any audio (AUX I/O) or serial connections (IOIO) depending on the model of MultiView
CAT5 Video System.
2. Connect the CAT5 cable to the LINK INPUT connection. If daisy chaining units,
connect the output CAT5 cable to the LINK OUTPUT connection.
3. Apply power. The LED should light and video should appear on the display (make
sure display is powered ON).
4. To adjust video levels and skew compensation see
Section 3.4
.
5. Please mount the AK600 in a location that ensures the ventilation holes and fan are
not blocked.
3.3.2 CONNECTIONS ON THE SINGLE-PORT VGA/AUDIO
The single-port units with audio support video and audio signals over CAT5 cable. The
audio signal is line-level summed Right/Left audio, and powered speakers are required.
You can also use the transmitters and receivers to make video-only connections without
audio. Figure 3-1 shows the Single-Port MultiView CAT5 Video System with Audio
Transmitter connections, and Figure 3-2 shows the receiver connections.
Figure 3-1. Connections on the UTx Universal Transmitter
.
Figure 3-2. Connections on the AK600 for video and audio.
