Page 7 of 9
Step 4:
● Unfold fly and stretch out all corners. Place the
fly over the tent. Attach the fly to the tent by
attaching the plastic hooks on the fly edges to
the D-rings on the steel uprights
(Fig. 10).
● With an adult on each corner of one side of the
tent, insert the end of the main upright poles into
the 4-way hub. Be sure the D-ring on the pole is
located at the top section. Both adults should lift
up the steel poles while raising one side of the
center of the tent. Place the bottom end of the
steel pole over the pin on the ring at the base of
the tent
(Fig. 11).
Assembly Instructions
Step 5:
● Stake the tent to the ground by inserting steel
stakes through the rings and webbing loops
around then tent floor. Hammer stakes into the
ground at a 45° angle using a hammer or mallet,
making sure to pull tent floor out evenly and snugly
(Fig. 12)
.
● Extend each of the guylines which are attached
to the fly edges. Make a loop at the opposite end
of the guylines by using slider as shown and place
loop over a tent stake. Tighten the guylines by
adjusting the slider
(Fig. 13)
.
NOTE:
Locate your tent to its final position before
securing it with stakes and guylines.
12
13
FIGURE 10
FIGURE 11
FIGURE 13
FIGURE 12
