- 24 -
- 25 -
seals. Nevertheless, in the first hours of exercise, a small loss points out only and exclusively an
arrangement of the seals and not a breakdown.
13.3. If there are some losses of oil between the body of the pump and the head of the pump, it is
necessary to remove the oil, to get off the head and to handle the substitution of the seals of the
head. For this operation it is necessary to contact a specialized and authorized assistance center.
13.4. Restarting the pump after the maintenance to verify that this is supplied of oil. The oil must be
replaced after the first 50 hours of operation and subsequently every 200 hours of operation;
the ability of the reservoir of the oil is equal to 0,55 liters. Use only and exclusively oil with brand
Esso Plus Motor Oil 20W30 or Shell Oil X100 20W40.
14. Boiler
14.1. To improve the power of the boiler, is absolutely necessary to clean the coil. Effect this operation
in the following way:
14.1.1. Get off the group boiler burner from the machine and to separate the boiler from the burner.
14.1.2. Remove the cover of the boiler.
14.1.3. Remove the band of the boiler freeing the serpentine one.
14.1.4. Use a rigid brush to eliminate the soot from the serpentine and an aspirator for the dust.
14.1.5. Reassemble the band, the cover and the burner again installing the group boiler burner
on the machine.
15. Electrodes
15.1. Periodically check the position of the electrodes so that to guarantee the best combustion and
to avoid the formation of the soot.
16. Fuel filter
16.1. To avoid the seizure or the breakup of the pump, because of the impurities in the fuel, the
circuit of the fuel is equipped with a filter, that must periodically be gotten off, and cleaned
with a jet of compressed air. The substitution of the filter is advisable when an effective cleaning
becomes impossible.
17. Water filter
17.1. Monthly check the filter of the water, both that predisposed on the machine and the possible
one installed by the consumer on the line of supply.
18. Demolition
18.1. To allow the recycling of the raw materials, it is to separate well: pack (if supplied), the exhausted
oils and the lubricants, the electric motors, metallic pieces, parts and components in plastics.
18.2. It is compulsory to respect the norms in force related to the production, detention, harvest and
disposal of the refusals, according to what established by the legislative decree 22/97. The
exhausted oils must be delivered to the National Consortium Obligatory, while possible pa
ckings must be digested according to what established by the title II of the legislative decree 22/97.
