Page 5
For technical questions, please call 1-888-866-5797.
Item 59544
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
Inspect Sprayer before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use Sprayer until repaired.
Follow all guidelines regarding chemicals sprayed, including MSDS instructions and EPA regulations.
Release pressure in Bottle by depressing the Trigger or Valve Stem.
Contents are under pressure and may spurt forcefully.
1. Before filling, depress trigger to ensure that
it operates properly and does not stick.
2. Loosen and remove the Filler Cap.
3. Pour liquid into the Bottle’s top opening.
Fill no higher than 2/3 full.
CAUTION! Use only with non flammable
cleaners, degreasers, penetrating oils,
solvents, and lubricants. Not for use with
water, or water based materials.
4. Insert the Filler Cap back into the
top of the Bottle and tighten.
5. Place air chuck (sold separately) on Valve
Stem to charge Bottle to 80-150 PSI.
CAUTION!
Maximum pressure
should not exceed 200 PSI.
6. Depress the Trigger to begin spraying.
7. The Sprayer will depressurize during operation.
When the decreased pressure affects the spray
pattern, use an air chuck (sold separately)
to recharge the Bottle until proper pressure
is achieved, then resume spraying.
Note:
The spray pattern can be changed
from diffuse to a pin stream.
8. To change spray pattern from diffuse to a
pin stream; unscrew the Pin Stream Nozzle,
remove the Spray Nozzle, then reattach
the Pin Stream Nozzle and tighten.
9.
When finished spraying:
•
Depressurize the Sprayer.
•
Dispose of liquid.
•
Clean the Sprayer according to
Maintenance Instructions.
•
Store Sprayer indoors out
of children’s reach.
