TH8750150
20-02-2015
MAD Disc Aligner
DA8700
en
7
29. The drive unit DU8610 must be equipped with a safety guard (SK-508), as specified in
this manual.
30. Make sure that the surface of the working area is level.
31. Maximum load capacity of top surface is 1 kg (2.2 Lbs).
32. Do not move the equipment while it is running.
33. Warning: machining generates hot chips of metal from the disc.
34. The accompanying risk of fire, injury or burns must be prevented by taking the follow-
ing safety precautions; Wear protective clothing, work gloves, a dust mask. Check
that a fire extinguisher is present.
35. If possible, always use the rubber silencer ring on the outer edge of the brake disc.
This will minimize vibration and/or noise.
36. MAD cannot be held liable for customized attachments or modifications of the equip-
ment.
37. Prior to using the equipment, damaged safety guards or other parts should be
checked in order to ascertain that they still function properly.
38. Check the alignment of the moving parts and their connections, possible part faults,
the set up and indeed any other conditions that might have an influence on the opera-
tion of the equipment.
39. If not otherwise indicated in the manual, damaged safety guards, cables, or other
parts must be replaced or repaired by an recognized technician.
40. Defective electric components must be replaced by a recognized technician.
41. In the interest of effectiveness and safety, keep the tips sharp and the equipment
clean.
42. Hand grips must be kept dry, clean and free from oil and grease.
43. Only maintain the equipment as described in this manual.
44. General repairs, repairs to damaged parts, as well as any other form of maintenance
should only be carried out by a recognized technician (possessing thorough electrical
and mechanical knowledge and experience) using genuine MAD spare parts.
45. Repairs and maintenance may only be carried out on the equipment if it has been
switched off and if the plug has been removed from the mains.
46. Prior to repairs on the drive unit DU8610, carefully short-circuit the connectors of the
capacitor to prevent electric shock injuries.
47. Always use original M.A.D. parts in carrying out repairs or maintenance.
48. Machining the brake discs can affect the brake performance. After the working check
if the deceleration meets the requirements of the law and the car manufacturer.
SAVE THESE SAFETY INSTRUCTIONS
Fig. 5
Fig. 6
Important Safety Instructions
