TH8750150
20-02-2015
MAD Disc Aligner
DA8700
en
29
Before carrying out maintenance activities, read the safety regulations contained in
this manual.
A. Ensure the bits are sharp and not damaged prior to each use. The bits should
be rotated frequently and replaced every 10 vehicles.
B. Clean the slides every 10 vehicles. Clean the guides between the block and the
slide with a brush, then apply a small amount of Lathe oil.
C. Clean the bit holder every 50 vehicles. To do this, first turn the adjustment knob
counterclockwise until the bit holder is completely out of the slide. Then clean
and lightly grease the holder. When reinstalling the bit holder, point the slot to-
ward the outside of the Lathe
D. On a weekly schedule, inspect cables and extension cables for damage and im-
mediately replace them as necessary.
Fig. 65
Fig. 66
Fig. 67
Phillips PH1
9.
Maintenance
Maintenance
