Macnaught OKTR585-1-001, Инструкция по эксплуатации

Страница: 20 / 24

E18
5. According to each mounting application, recommend Guide Arm positions.
6. Replace and tighten the nuts and washers.
7. Tighten the drive spring by turning the spool two or three revolutions and engage the latch
pawl.
8. Pull the hose through the roller opening in the guide arm and replace the hose bumper.
SERVICE INSTRUCTIONS
CAUTION: Remove all tension before servicing. Hazards or unsafe practices MAY
result in minor personal injury, product or property damage.
WARNING: Before performing any service, always disconnect and lock out
compressed air or fluid, and remove all spring tension. Hazards or unsafe
practices COULD result in severe personal injury or death.
User servicing of the reel is limited to replacing input/output hoses only. Refer all other repairs
to an authorized service person. Failure to do so can result in person injury and/or equipment
damage and may void the warranty.
- Replacing the hose
1. To remove the hose.
2. Pull out the hose leaving 2 to 3 feet on the spool. Engage the latch pawl.
3. Unthread the hose at the connection to the swivel tube. Remove the hose.
4. To install the hose.
5. Route the hose through the guide arm rollers and opening of the spool. Apply thread tape or
sealant to hose threads.
6. Screw hose fitting into threaded fitting on swivel. Tighten connection with a wrench on fitting.
Install hose bumper on working end of hose if required.
7. Disengage latch pawl and allow hose to retract.
- Replacing the swivel
1. If the swivel leak, replace the O-ring or seal (#31) and washer (#30) by removing the lock
washer (#40) and the part of the swivel shift.
2. If the balls (#37) wear-out, replace by removing the lock washer (#40).
3. Replace the New seal by clipping the lock washer (#40). Replace the part of the swivel shift
by clipping the lock washer (#40).
WARNING:
Your risk from these exposures varies, depending on how often you
do this type of work. To reduce your exposure to these chemicals: work in a well
ventilated area, and work with approved safety equipment, such as those dust
masks that are specially designed to filter out microscopic particles.