Macnaught OKTR585-1-001, Инструкция по эксплуатации

Страница: 19 / 24

E17
Floor Wall Ceiling
ADJUSTMENTS
- Spring tension
WARNING: Use extreme caution; reel under tension. Avoid releasing latch
mechanism.
1. If necessary, adjust spring tension on reel by adding or removing wraps of hose from spool,
one wraps at a time, until desired tension is obtained. Add wraps to increase tension.
Remove wraps to decrease tension.
2. Pull out the hose until the latch pawl is engaged. Loose the hose bumper, then add wraps
and decrease the wraps.
CAUTION: When adding wraps of hose, be careful not to exceed the winding
mechanism’s spring capacity. Add just enough wraps of hose to achieve the
desired tension. Damage to the winding mechanism will result if spring is
over-tensioned.
- Adjusting the hose bumper
1. Pull out the hose until the latch pawl is engaged. The hose bumper may be adjusted by
loosening the slotted screws. Slide the bumper to the desired position and tighten the screws
before pulling hose to disengage the latch pawl.
- Removing and positioning Guide Arm
1. Pull out hose until the latch pawl is engaged. Remove bumper by removing the slotted screws.
2. Disengage the latch awl while maintaining a firm hold on spool. Turn the spool hand over
hand approximately two or three revolutions in the direction of the direction of the drive
spring until tension is removed.
3. Remove the nuts and washer holding the guide arm and shift to base.
4. Revolute the guide arm and adjust to any of the three positions hinted.