Maclaren Grand Tour LX, Руководство пользователя

Страница: 15 / 28

15
to operate the lights
To use the lights for the first time it may be
necessary to remove the isolating strip in the
battery compartment - see instruction 12.
The lights are provided as a safety feature to
provide visibility of the stroller in the dark –
they will not light the way.
A
To turn the lights ‘on’ use the on/off button
located beneath the footrest at the front of the
stroller – the lights will display as a continuous
white light.
B
Pressing the “mode” button, also located on
the underside of the footrest, will change the
white light to an alternating white/red/green
flashing display.
C
Pressing the mode button again will change the
display to a flashing red/green display.
D
Pressing the mode button again will return to
display to a constant white light.
A remote operating unit is provided and may
be used to change sequence of the display as
described above.
NOTE
The sensor for the remote beam is located
in one of the light units and it may be necessary
to angle the sensor to allow a direct line to the
sensor to give efficient operation. The remote
operating unit has a range of 6 m (10 ft). The
Remote Unit has a cord and clip attached which
may be attached, for safe keeping to the clip in
the pocket on the rear of the seat.
E
To switch the lights ‘off’ either use the on/off
switch on the stroller or on the remote ‘button –
this automatically puts the lights on to a 24 hour
standby and activation by operating the on/off
button on either the footplate or the remote
during this period will resume the previous
mode. After this period the full sequence from
‘A’ above will need to be used. The mode may be
changed using either the mode button on the
footplate or the ‘+ button’ on the remote.
11
E
RECOMMENDATION
When turning “off” the lights,
please make sure the “master ON/OFF” switch
beneath the footplate is used. This “powers down”
the entire electronic system so that no battery
“drainage” is incurred. The Remote Control unit
will not function when the entire system is
powered down.
If, however, this master switch is not used there is
an automatic “power down” function which kicks in
after 24 Hours of non-use.
Once the “master” ON/OFF switch beneath the
footplate is used to turn “OFF” the unit, the same
“master” ON/OFF” switch beneath the footplate
must be used to power “ON” the lights also allowing
the Remote Control unit to be used.
The normal function of the product may be
disturbed by Strong Electro Magnetic Interference.
If so, simply reset the product to resume normal
operation by following this instruction.
IMPORTANT
Instruments and electrical components
are excluded from the Sovereign Lifetime Warranty
™.
B
C
D
A