Mackie DIGITAL XBUS - SOFTWARE, Руководство по замене установки

Страница: 4 / 25

2.
Removing all power supply cables from the motherboard. You will find a 20 pin Molex
connector located at the front center of the Iwill motherboard. Next you will need to
remove the 4 pin Molex connector located to the left of the black RAM socket.
3.
Remove the flat IDE ribbon cable located in the upper right hand corner.
Note: this will be a blue header labeled IDE1.
4.
Next we will remove the ribbon cabled used to connect the USB from the Digital X Bus
daughter board to the Iwill motherboard. Remove the end of the cabled connected to the
Iwill motherboard (figure 3 below). Leave the ribbon cabled connected to the Digital X Bus
daughter board at this time (figure 4 below).
Figure 3