MachineryHouse BS-461AS, Инструкция по эксплуатации

Страница: 14 / 35

11
- Open the vise more than 250mm.
- Attach and Tighten posts bolts’ (A) on to vises.
Then attach the vertical press to the top of the
post bolts. Connect the Hydraulic connector
(B).
- Attach the nuts (H) on to the posts, but do not
make the nut (H1) on moveable vise jaw too
tight. *Otherwise, the vise won’t be able to
clamp the work piece or the post bolts will be
damaged.
- Adjust the vise press (E) to sit approximately 5-
8mm above the work piece. Loose nut (C) and
rotate the bolt (D) to raise or lower the vise
press (E).
- Adjust the vise press width to fit the work piece
size. Loosen screws (F) on both sides of the
vise press then move press extender bars (G)
desired width.
- Turn OFF the hydraulic pump.
- Attach the hydraulic hose to connecter (B) and
then attach the quick link connecter (J) to the
90-degree fitting.
- Switch ON the hydraulic pump.
6 OPERATION CYCLE
6.1 Operation cycle
- Turn on the main connect. on the door of
electrical box. Then the Power indicator (A) will
light up.
- Start the hydraulic system, use button (D).
- Raise the saw bow, Use bow up button (H).
- Open the vise, use vise open button (J)
- Load the working material.
- Secure the material, use the vise close button
(I).
- Base on the diameter of the material; set the
saw bow’s
height: contactor (5.1 L).
- Choose the blade speed appropriate for the
material.
- Start operation by using the start button (E)
- When the cutting operation is finished the saw
bow will automatically rise to the preset height
ready for the next operation.
6.2 Stopping or emergency stopping
There are two ways to stop the machine in an
event of an emergency or improper operation.
- For most situations, use the stop switch 6.1 F
Using the stop switch 6.1 F will not reset the
controls and your operation setting. The blade
and drive motor will stop. Then the saw bow
stay arise to the top position. open the vise to
check the issue. After checking, close the vise
and start to cutting
.
- For unsafe and emergency conditions use the
emergency stop button 6.1 C. Using
emergency stop button 6.1 C will stop the
machine in last position. The motor and
hydraulic will stop and control setting will be
reset.
- To restart, the emergency stop button 6.1 C
must be turned to release from the pressed
position.
7 ROUTINE AND SPECIAL
MAINTENANCE
The maintenance jobs are listed below, divided
into daily, weekly, monthly and six-month
intervals. If the following operations are
neglected, the result will be premature wear of the
machine and poor performance.
7.1 Daily maintenance
- Give general cleaning to the machine to remove
accumulated shavings.
- Clean the lubricating coolant drain hole to avoid
excess fluid.
- Top off the level of lubricating coolant.
- Check blade for wear.
- Rise of saw frame to top position and partial
slackening of the blade to avoid useless yield
stress.
- Check functionality of the shields and
emergency stops.
7.2 Weekly maintenance
- Thoroughly clean the machine to remove
shavings, especially from the coolant tank.
- Removal of pump from its housing, cleaning of
the suction filter and suction zone.
- Clean the filter of the pump suction head and
the suction area.
J
A
B
C
D
E
F
G
H
I
J
K
Page 14 Instruction Manual for BS-461AS (B035A) 03/12/2014