MachineryHouse BS-461AS, Инструкция по эксплуатации

Страница: 8 / 35

5
3.5 Chip tray
Removable chip tray for capture of chips and
debris.
3.6 Blade broken micro switch
This machine is equipped with automatic power
shut-off safety device to prevent any further
damage when a blade has been broken. There is
a reduction in tension when an adjustment bolt
actuates micro switch’s plunger. To keep the
micro switch in proper contact with the blade’s
tension. An adjustment of the actuator bolt is
required.
3.7 Chip brush
This model has a powered chip brush driven by
an axle transfer from the drive motor. The chip
brush is designed to clean the blade thus
prolonging the life of the blade.
3.8 Open Blade Cover Safety Device
When blade cover is open, close the blade cover
as instructed below:
1. Use one hand on the cover handle to hold
the blade cover.
2. Use the other hand to push in the safety
plate (Fig. A), so the bracket will release
(Fig. B).
3. Lower the cover down slowly and carefully.
3.9 Speed change dial
The speed change dial adjusts the variable speed
transmission in blade speed. Change only while
blade is moving.
This machine has a variable speed transmission
using a variable pulley - system. The speed is
changed by rotating the speed changer dial to
adjust the width of the pulley discs. When
compressed, the pulley discs cause the belt to
ride the outer edge of pulley discs and changing
the speed. The speed must be changed while belt
is moving.
3.10 Blade angle scale
The scale indicates the cutting angle of the blade.
The scale has preset stops at every 15  .
Page 8 Instruction Manual for BS-461AS (B035A) 03/12/2014