MachineryHouse BS-461AS, Инструкция по эксплуатации

Страница: 7 / 35

4
2.8 Deactivation of machine
If the machine is to be out of use for a long period,
it is advisable to proceed as follows:
1) Disconnect from the power supply
2) Loosen the tension on the blade
3) Release the bow return spring
4) Empty the coolant tank
5) Carefully clean and grease the machine
6) If necessary, cover the machine.
Dismantling (due to deterioration and/or
obsolescence)
As a General Rule,
If the machine is to be permanently demolished
and/or scrapped, divide the material to be
disposed of according to type and composition, as
follows:
1) Cast iron or ferrous materials
,
composed of
metal alone, are secondary raw materials, so
they may be taken to an iron foundry for re-
smelting after having removed the contents
(classified in point 3).
2) Electrical components, including the cable and
electronic material (magnetic cards, etc.), fall
within the category of material classified as
being assimilated to urban waste according to
the laws of your local, state, or federal
government, so they may be set aside for
collection by the public waste disposal service;
3) Old mineral and synthetic and/or mixed oils,
emulsified oils and greases are considered
hazardous or special refuse, so they must be
collected, transported and disposed of at a
special waste disposal service.
NOTE: The standards and legislation concerning
refuse is in a constant state of evolution, therefore
is subject to changes. The user must keep
informed of the regulations at the time of disposal
as these may differ from those described above.
3 DESCRIPTION OF MACHINE PARTS
3.1 Control panel
A. Main power indicator light – indicates that
main power is active.
B. Hydraulic flow control valve: turn clockwise to
increase bow down rate, counter clock wise to
decrease the cutting rate.
C. Emergency Stop Button – Press to stop all
machine functions.
D. Hydraulic start switch – actives hydraulic
power.
E. Start Blade – press to start cutting cycle-
blade start and descend the saw bow.
NOTE: before blade starting, press vise close
button (3.1 I) to clamp work piece well.
F. Stop cutting - Press to stop cutting cycle.
G: Bow Down Button - Press to descend the saw
bow.
H. Bow Up Button – Press to raise the saw bow.
I. Vise close Button – press to close the vise.
J. Vise open Button – press to open the vise.
K. Coolant start switch – Turn right to activate or
turn left to stop coolant flow.
3.2 The saw bow
Machine parts consisting of drive members (gear
motor, variable speed motor, and flywheels),
tightening and guide (blade tightening slide, blade
guide blocks) of tool.
3.3 The vise system
A hydraulic vise is used for clamping work
material. Each of the vises has a miter slot, which
is good for the right or left side’s angle cutting to
60°.
3.4 The base
The base is the structure supporting the saw bow
(the bow pivot point and respective blocking
system), the vises, and containing chip tray and
coolant system.
A
B
C
D
E
F
G
H
I
J
K
Page 7 Instruction Manual for BS-461AS (B035A) 03/12/2014