MacDon Swath Compressor, Руководство по эксплуатации и запасным частям

Страница: 50 / 90

215953
42
Revision A
1021929
A
Figure 3.20: Swath Compressor Lock
1. Rotate handle (A) counterclockwise to disengage the lock
on the left rear support.
2. Start the engine, set ground speed lever (GSL) in PARK, and
ensure that the header is disengaged.
1015455
B
A
Figure 3.21: Operator
’
s Console
3. Adjust the swath compressor position to the target (or
preferred) operating height using controls (A) and (B) on
the console. Set the target operating height to 6 if there is
no preferred operating height.
4. Engage and then disengage the header. The swath
compressor will raise fully.
1031053
A
Figure 3.22: Display
5. Engage the header and begin cutting crop. When the
ground speed exceeds 2.5 km/h (1.6 mph), the swath
compressor will lower to target (or preferred) height (A).
6. Shut down the engine, and remove the key from the
ignition.
7. Check the formation of the windrow.
•
If necessary, adjust target height (A).
•
If the edges of the windrow are not sufficiently pressed
into the stubble, adjust the side deflectors. For
instructions, refer to
3.3.5 Adjusting Side Deflectors,
page 44 .
•
If the swath compressor shield raises too easily in dense
windrows, adjust the compression. For instructions,
refer to
3.3.4 Adjusting Compression, page 43 .
OPERATION