MacDon R85, Руководство по сборке

Страница: 119 / 122

214367
111
Revision A
Predelivery Checklist
Perform these checks and adjustments before delivering the machine to your Customer. If adjustments are
required, refer to the appropriate page number in this manual. The completed Checklist should be retained by
either the Operator or the Dealer.
WARNING
Do NOT operate the machine with the driveshields open. High speed rotating components may throw
debris and could result in death or serious injury.
CAUTION
Carefully follow the instructions given. Be alert for safety-related messages that bring your attention to
hazards and unsafe practices.
Header Serial Number:
Table .16 Predelivery Checklist
ü ü
Item Reference
Check for shipping damage or missing parts. Be sure all
shipping dunnage is removed.
—
Check for loose hardware. Tighten to required torque if
applicable.
5.1 Torque Specifications, page 97
Check main drive belt tension.
4.1 Checking Drive Belts, page 81
Check auger drive belt tension.
4.1 Checking Drive Belts, page 81
Check header angle. Set center-link to middle of
adjustment range.
3.11 Attaching Header to an M Series
Windrower, page 31
Check header float: 426
–
471 N (95
–
105 lbf).
4.2 Checking Header Float: M200 and M205
Windrowers, page 83
Check if header is level.
4.4 Checking Header Level, page 86
Check if side forming shields are evenly set to desired
position.
3.10 Installing Forming Shield, page 28
Check if rear fluffer deflector is about halfway down.
3.10 Installing Forming Shield, page 28
Check if swath baffle lever is set about halfway.
3.7 Unpacking Curtains, page 18
Check if gauge rollers/skid shoes are evenly set.
4.6 Checking Gauge Rollers or Skid Shoes,
page 91
Check that bevel gearbox lube level.
4.7 Preparing the Bevel Gearbox, page 92
Check if bevel gearbox breather is installed.
4.7 Preparing the Bevel Gearbox, page 92
Check conditioner roll timing gearbox lube level.
4.8 Preparing the Conditioner Roll Timing
Gearbox, page 93
Check if conditioner roll timing gearbox breather is
installed.
4.8 Preparing the Conditioner Roll Timing
Gearbox, page 93