214075
24
Revision A
3.3
Attaching R1 Series Self-Propelled Header to M155
E4
Windrower: Hydraulic Center-Link without Self-Alignment
Figure 3.30: Header Support
1.
Remove hairpin (B) from clevis pin (A) and remove
clevis pin from the header supports (C) on both sides of
the header.
Figure 3.31: Header Float Linkage
CAUTION
To prevent damage to the lift system when lowering
header lift linkages without a header or weight box
attached to the windrower, ensure the float engagement
pin is installed in storage position (B) and NOT in
engaged position (A).
CAUTION
Check to be sure all bystanders have cleared the area.
IMPORTANT:
Before starting engine, remove protective cover from exhaust stack.
Figure 3.32: Ground Speed Lever
2.
Start the engine and activate the HEADER DOWN
button (A) on the ground speed lever (GSL) to fully
retract header lift cylinders.
