215104
87
Revision A
1011480
A
B
Figure 3.122: Operator Console
Normal start (all engines):
6.
Follow these steps when starting engine in temperatures
above 16°C (60°F):
a.
Move throttle fully back to START position (A).
b.
Sound horn three times.
c.
Turn ignition key (B) to RUN position.
NOTE:
A single loud tone will sound, engine warning lights will
illuminate, and the cab display module will display
HEADER DISENGAGED and IN PARK.
d.
Turn ignition key (B) to START position until engine
starts and then release the key. The tone will cease and
warning lights will go out.
WARNING
If starter engages with steering wheel unlocked, ground speed lever out of NEUTRAL, or header clutch engaged, do NOT
start engine. Refer to the technical manual.
IMPORTANT:
•
Do
NOT
operate starter for longer than 15 seconds at a time.
•
If the engine does
NOT
start, wait at least 2 minutes before trying again.
•
After the third 15-second crank attempt, allow the starter motor to cool for 10 minutes before further cranking
attempts.
•
If the engine still does
NOT
start, refer to Table
Cold start:
NOTE:
Engines are equipped with cold start assist system.
7.
When the engine temperature is below 5°C (40°F), follow the procedure for a normal start. Refer to Step
,
but adhere to the following
NOTE
and
IMPORTANT
statements while starting the engine.
NOTE:
Engine will cycle through a period when it appears to labour during engine warm up. The throttle is nonresponsive
while engine is in warm up mode. Warm up mode lasts between 30 seconds and 3 minutes depending on the
temperature. The throttle will become active after the engine has stabilized and is idling normally.
IMPORTANT:
Do
NOT
operate engine above 1500 rpm until engine temperature is above 40°C (100°F).
