215104
116
Revision A
4.3.12
Activating the Swath Compressor
An optional swath compressor (MD #C2061) is available. Before using the swath compressor, you must activate it on the
cab display module (CDM).
NOTE:
•
CDM5 (version 512 or later) and WCM2 (version 237 or later), or WCM3 (version 116 or later), are required to operate
the swath compressor.
•
The Double Windrow Attachment (DWA) system must be disabled in the CDM when setting up the swath compressor.
•
Users can activate and set up the swath compressor via in-cab controls without a header attached to the windrower.
Use the following procedure when installing and setting up the swath compressor:
CAUTION
Check to be sure all bystanders have cleared the area.
1011760
CXXX
EXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.41: CDM Programming Buttons
1.
Turn the ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
CXXX
EXXX
NO/YES
SWATH COMPR INSTALL?
1030044
B
A
Figure 4.42: Swath Compressor Controls
4.
Press SELECT (B) until SWATH COMPR INSTALL? is displayed
on the upper line.
•
NO/YES is displayed on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).
6.
Press SELECT (B) until CALIBRATE SENSORS is displayed on
upper line. NO/YES is displayed on lower line.
7.
Press right arrow (A) to select YES. Press SELECT (B).
•
TO CALIBRATE SELECT is displayed on upper line.
•
HEADER HEIGHT is displayed on lower line.
8.
Press right arrow (A) to scroll through choices until SWATH
COMPR HT is displayed. Press SELECT (B).
•
SWATH SENSOR CAL is displayed on upper line.
•
SWATH UP TO START is displayed on lower line.
