6.
Press soft key 3 (A) to remove float.
Figure 3.30: HPT Display
CAUTION
Check to be sure all bystanders have cleared the area.
7.
Press HEADER DOWN switch (A) on the ground speed
lever (GSL) to fully retract header lift cylinders.
8.
Press REEL UP switch (B) on the GSL to raise the
center-link until the hook is above the attachment pin
on the header.
IMPORTANT:
If the center-link is too low, it may contact the
header as the windrower approaches the header
for hookup.
Figure 3.31: GSL
9.
Drive the windrower slowly forward until the draper
header supports (A) enter the header legs (B).
Continue driving slowly forward until lift linkages
contact the support plates in the header legs and the
header nudges forward.
10. Ensure that lift linkages are properly engaged in header
legs and are contacting the support plates.
Figure 3.32: Header Leg and Draper Header
Support
214017
29
Revision A
