214804
182
Revision A
Figure 4.162: Hydraulic Motor
14. Apply a light coat of silicone to motor flange.
15. Position hydraulic motor (A) onto gearbox as shown
and secure with two hex head bolts (B) with thread
locking compound, two flat washers (C), and two lock
washers (D). Torque to 112 Nm (83 lbf·ft).
16. Time the rolls. Refer to
4.13.11 Checking/Adjusting Roll
Figure 4.163: Conditioner Drive
17. Position channel (B) against endsheet as shown,
picking up the three holes in endsheet.
18. Install two carriage bolts and nuts (A) in lower
two holes.
Figure 4.164: Header Drive
19. Install carriage bolt and nut in upper hole (B) with head
facing inboard.
20. Install two hex bolts with lock washers and flat washers
in remaining locations (A).
21. Tighten hardware.
22. Close conditioner driveline shield and endshield.
Содержание A40-D
