214804
128
Revision A
Replacing Center Stub Guard on Double-Knife Header
Check daily that guards are firmly bolted to the cutterbar, and not worn or broken. Replace as required. A worn or
broken guard can be replaced without removing knife from cutterbar. This procedure applies to the center guard
where the two knives overlap on a double-knife header.
IMPORTANT:
Replace adjacent guards when replacing center guard.
Figure 4.37: Center Guard
–
Double Knife
IMPORTANT:
Ensure center guard (A) has offset cutting surface (B).
IMPORTANT:
Ledger surfaces of center and adjacent guards must be
vertically aligned to avoid interference with knife sections.
Figure 4.38: Center Hold-Down
–
Double Knife
IMPORTANT:
Hold-down (A) must accommodate the two overlapping
knives at center guard location on double-knife header.
Ensure replacement is the correct part. Hold-down is
actually an inverted stub guard (MD # 118346).
Содержание A40-D
