Sensopress_LCD_Rev_00_Eng.doc Eng
14
LEVEL: 301 cm in Figure 8). By pushing the
Yes/+, No/-
buttons it is possible to increase or to
decrease the wanted maximum threshold; the maximum threshold cannot be lower than the minimum
one; if this gets reached the device will start again from the point 899 cm; with the
Menu
button it is
possible to memorize the set-up value and it is possible to go to the changing state request; if no
button is pushed the device goes to the
AUTO
state.
Figure 8
To set-up the high threshold of a channel which is not the chosen one it is necessary to go to the
CHANNEL mode and choose the wanted channel by following the instructions described in paragraph
4.3.1
CHANNEL Mode
4.3.4
MANUAL Mode
The
MANUAL
Mode is necessary to activate or disactivate manually the relays of the different
channels.
It is possible to enter the MANUAL Mode from any other mode by selecting the sign
GO to MANUAL
with the
Menu
button and by pushing
Yes/+
.
On the display it is shown the state name (
Manua
l) and the relay position (Relay: OFF, Relay: ON)
and the number of the channel correspondent to the relay. (in the single output version there is no
channel indication)
In the
MANUAL
state
, by pushing button
Yes/+,
it is possible to intervene on the relay, so that to pass
from ON to OFF
Button
No/-
is used to select the channel on which one wants to intervene manually.
The activating of the relay in the
MANUAL
mode is not linked to the channel state. It can be enabled
or disabled.
With the
Menu
button it passes to the state of chaning request.
NOTE
!Attention: in the MANUAL state the device does not go back automatically to the
AUTO
state!
If needed to leave the MANUAL state use the Menu button as usual.
Chosen channel
In the single
output version
it is shown
HIGH
High threshold possible to set-up,
for the chosen channel, with the
Yes/+ e No/- buttons
Low threshold currently set-up for
the chosen channel
