Instruction Manual
MAN-070
13
www.macmedical.com
Programming the Replacement Memory Control Pad
After the new Memory Control Pad has been installed, it must be programmed.
1.
Press and hold Buttons “1”, “2”, and the “UP” Arrow at the same
time. The Memory Control Pad is now in the adjustment mode.
2.
Release Buttons “1”, “2”, and the “UP” arrow. Press the “UP” arrow
until the display reads “S7”.
3.
Next, press the “S” button.
4.
Press the “DOWN” Arrow. The table will now move down. Verify
height of table is US:36”/EU:91cm with a tape measure.
5.
Press and hold “2” button until “000” is displayed. Press GREEN
(SET) Button. Display will now read “036”.
6.
Press and hold “UP”Arrow until the table raises to US:43”/EU:91cm.
Verify height of table is 43” with a tape measure.
7.
Press and hold “1” button until the display reads “109”.Next, press
the “S” button.
8. The Memory Control Pad is NOW ready for use.
HOLD AT THE
SAME TIME
RELEASE
BUTTONS
PRESS UP ARROW
PRESS SET BUTTON
PRESS SET (GREEN) BUTTON
HOLD BUTTON #2
DISPLAY READS 000
PRESS SET (GREEN) BUTTON
PRESS #2 BUTTON
HOLD UP ARROW
HOLD BUTTON #1
PRESS SET BUTTON
