Instruction Manual
MAN-070
10
www.macmedical.com
3. Saving of a position
a. This function allows the user to save a particular operating height on one of the four preset buttons.
b.
Press the “S” button (Display: “5 –“).
c.
Press one of the following buttons: “1”, “2”, “3”, or “4”.
d.
After having pressed one of the position buttons listed above, an “S” and one of the position buttons is
read on the display (i.e. “S3”).
e.
At the end of the memory procedure, a double “Click” is heard and after 2 seconds the actual height is
read on the display (i.e. “073”).
f. If there is a power failure or the unit is unplugged, the programmed pre-sets are retained (up to 24
hours).
4. Reset of the Control Unit
a.
Press and hold “1”, “2”, and the “Up” arrow at the same time until it flashes “S5”. The control is now in
the adjustment mode.
• Release “1”, “2”, and the “Up” arrow. Press the Up arrow until the display shows “S7”. Then press “S”
to set.
b. Then press the down arrow. The table will now move down. Checking with a tape measure, lower the
table down to US:36’’/EU: 91cm.
c.
Then hold “2” until it reads “000”.
• Then press “S” to set. It will then display “036”.
d. Hold the Up arrow to US:43’’/EU:109cm (check the height with the tape measure).
• Then press “1” until it reads “109”. Then press “S” to set.
5. Setting of Indicated Height
a.
Press the “S” button. Display will read “5 –“.
b. If the key is not pressed within 5 seconds, the control returns to standard mode again.
c.
Press the “Down” arrow button now for about 5 seconds until the display starts flashing. (Example:
display flashes: “073”).
d.
The height can also be set with the “Up” (plus) or with the “Down” (minus) arrow buttons. During this
procedure the table does not move.
e.
If the position is correctly set, the new height can be saved by pressing the “S” button.
• The position is saved and the display stops flashing.
• The new height is also saved, if no button is pressed within 5 seconds the display stops flashing
automatically.
Work Tables with Electronic Adjustable Height Option - Control Panel Setup and Operation (continued)
