36
37
MLMP450HP40 By MacAllister
MLMP450HP40 By MacAllister
In
more
detail
. . .
In
more
detail
. . .
The golden rules for care
WARNING!
Always switch the product off, disconnect the spark plug connector
and let the product cool down before performing inspection, maintenance and
cleaning work!
DO NOT touch a rotating blade.
1. Keep the product clean. Remove debris from it after each use and before storage.
2. Regular and proper cleaning will help ensure safe use and prolong the life of the
product.
3. Inspect the product before each use for worn and damaged parts. Do not operate
WARNING!
Only perform repairs and maintenance work according to these
General cleaning
1. Clean the product with a slightly damp cloth and mild soap. Use a brush for areas
that are hard to reach.
2. In particular clean the air vents (9) after every use with a cloth and brush.
3. Remove stubborn dirt with high pressure air (max. 3 bar).
NOTE:
Do not use chemical, alkaline, abrasive or other aggressive detergents
or disinfectants to clean this product as they might be harmful to its surfaces.
4. Check for worn or damaged parts. Replace worn parts as necessary or contact an
authorised service centre for repair before using the product again.
Maintenance
Before and after each use, check the product and accessories (such as application
tools) for wear and damage. If required, exchange them for new ones as described in
this instruction manual. Observe the technical requirements.
Underbody and cutting device
WARNING!
Wear protective gloves when working on the cutting device and
close to it! Use proper tools to remove debris, e. g. a wooden stick! Never
use your bare hands!
Always use original spare parts for replacement. The cutting device must be
DAYE 26300100401.
Do not attach
any other type of cutting device!
The replacement of the cutting device should be done by an experienced user!
Rework or sharpening blades is not recommended unless it is done by a repair
NOTE:
We strongly recommend jacking the product up when performing
inspection and work on the cutting device. Avoid tilting the product in order to
prevent fuel and oil leakages.
1. Keep the underbody and cutting device (23) clean and free of debris. Remove
clippings from the discharge chute (24).
2. Check all nuts and bolts periodically for tightness before operation. After prolonged
use, especially in sandy soil conditions, the cutting device will become worn and lose
device should be replaced.
3. Keep the cutting device (23) sharp to ensure a good cutting performance. Replace a
worn or damaged cutting device with a new one of the same type or have it sharpened
4. Loosen the hex bolt (23f) anti-clockwise using a suitable wrench and remove it
(23e), cutting device (23), support (23d), ring (23c)
and pin (23b) (Fig. 21).
5. Replace the cutting device with a new one of the same type. Slide the pin (23b)
into the slot on the spindle (23a)
(23c), support (23d), locking
(23e) and hex bolt (23f). Tighten the hex bolt clockwise with 40 N m min,
50 N m max. to ensure safe operation of your product.
Care and maintenance
Care and maintenance
