Mac Afric ML392C I, Руководство по обслуживанию

Страница: 15 / 21

14
●
Remove flange and blade, clean it well.
●
Mount blade and lock nut again, screw the lock nut tightly, down the bench and lock it.
●
Center the splitter knife. If not, loose the fixing nut, adjust it.
Preparation
●
Turn-off the machine and take the plug off the socket.
●
Mount spindle hood 1 and guide 3, then cover the guide 3.
●
Mount saw cover 9 on the splitter knife. Adjust the knife and position it at 2mm from the
blade, tighten the lockbar again.
●
Adjust guide 7 according to the degree of ruler 5. Guide 7 is used for parallel sawing. Lock
guide 7 by bar 6, making the larger surface of guide 7 towards right side.
Caution: Make the turn-button 1 in the position of R (Fig.14). Clip the workpiece well when
angle cutting operation (Fig.5).
●
Connect the chip suction plant with cover 9 and the below sawing dust hole, the hole Φ of
cover 9 is 40mm,the below sawing dust hole is
Φ
80mm.
●
Take the position as Fig.12 showing during operation.
Instruction for use
●
Wear goggles.
●
For too short workpiece, use push board please.
●
For long workpiece, use outfeed supports.
●
Check that the wood doesn't have cracks or dangerous knots.
●
Make the wood advance uniformly and slowly.
●
Remove off-cuts and cut pieces in contact with the saw blade by means of wood and never
use your hand to do so.
●
Do not remove the workpiece when the cut already started.
●
To obtain clean cuts without chippings, use blades having short pitch tooth.
●
Keep knives sharp enough.
●
Be sure the blade is in good condition.
●
Press the E-button if there is something wrong.
●
Mount sawing cover 9 well enough.
●
At the end of work, turn-off the machine and take the plug off the socket, maintenance the
machine.
●
Dismount saw blade, mount saw cover 9 as Fig. 9 showing. Cover the arbor by guide 3.
8 Milling
(Fig.4)
8.1 Preparation
●
As Fig.13 showing, lock guide 8 by lockbar 7. Let the cover 6 fixed onto guide 8 cover the
arbor completely. Fix the hood 10 onto the splitter knife by lockbar 9.
●
Dismount arbor hood 1 (Fig.9).
●
Adjust the cutters, make the sides of the cutters align with the side surface of the toolpan,
Fig.13Drilling Protective diagram