mabe SMV630DEWWY00, Руководство пользователя

Страница: 48 / 72

34
installation
step 1.
Remove the literature and accessories bag fom the dryer dru m.
step 2.
Place the corner posts from dryer box - or two boards - on the floor and turn
step 3.
Remove the foam rubber from under the dryer by pulling at the sides and
breaking them away from the dryer le gs. Be sure to remove all of the foam pieces
around the legs.
step 4.
Place dryer back to a vertical position.
step 5.
Move the dryer to the
desired location.
step 6.
step 7.
step 9.
Make sure the dryer is properly operating.
step 10.
Place the Owner's Manual and Installation Instructions where they will be
noticed by the customer.
preparing to install the new dryer disconnecting the gas supply:
gas dryer installation instructions
Pull here to
separate the foam
pads from the front
leveling leg.
Leveling legs
Pull here to separat e
the foam from the
back leveling leg.
New flexible connector
for gas s upply line
approved by CSA (AGA)
Gas inlet
Duct
opening
Duct
tape
10 cm diamete r
metal duct
Duct
tape
Turn gas inlet to
the OFF position.
DISCONNECT AND DISCARD
OLD FLEXIBLE GAS
CONNECTORS AND
DUCTING MATERIAL
WARNING: NEVER REUSE
FLEXIBLE CONNECTORS.
Using old flexible connectors may cause
leaks or personal injury. Always use new
flexible connectors when installing gas
operating appliances.
WALL
EXHAUST DUCT
OPENING
MAKE SURE THE
EXHAUST HOOD
OPENS AND
CLOSES SMOOTHLY
the dryer upside down.
Pull here to separate
the foam pads from
the front leveling leg.
Adjust leveling legs to fit
the height of the washer. Dryer
must be leveled and firm over its
4 leveling legs.
If yours is a gas dryer, connect
the gas supply and check for gas leaks.
Connect the current (see ELECTRICAL
CONNECTION INFORMATION in
these instructions).
Connect air flow exhaust duct (See EXHAUST DUCTWORK INFORMATION).
WE RECOMMEND INSTALLING YOUR
DRYER BEFORE YOUR WASHER.
THIS WILL ENABLE DIRECT ACCESS TO A
SIMPLER EXHAUST CONNECTION.
REMOVING LINT FROM THE
EXHAUST WALL OPENING
step 8.
48