MAAX 300 Series, Руководство пользователя

Страница: 42 / 71

42 Owner’s Manual
E
nglish
READY-IN-REST MODE
READY/REST appears in the display if the spa is
in Rest Mode and the Jets 1 Button is pressed.
It is assumed that the spa is being used and
will heat to set temperature. While Pump 1
High can be turned on and off, Pump 1 Low
will run until set temperature is reached, or
1 hour has passed. After 1 hour, the System
will revert to Rest Mode. This mode can also
be reset by entering the Settings Menu and
changing the Heat Mode.
FILLING YOUR SPA
PREPARATION AND FILLING
Fill the spa 5-6” below the lip of the spa. Be
sure to open all valves and jets in the plumb-
ing system before filling to allow as much air
as possible to escape from the plumbing and
the control system during the filling process.
After turning the power on at the main power
panel, the top-side panel will display a splash,
or startup screen.
PRIMING MODE
After the initial start-up sequence, the control
will enter Priming Mode and display a Priming
Mode screen. Only pump icons appear on
the priming mode screen. The system will
automatically return to normal heating and fil-
tering at the end of the priming mode, which
lasts 4-5 minutes. During the priming mode,
the heater is disabled to allow the priming
process to be completed without the possibil-
ity of energizing the heater under low-flow or
no-flow conditions. Nothing comes on auto-
matically, but the pump(s) can be energized
by selecting the “Jet” buttons. Manually exit
Priming Mode by pressing the “Exit” Button.
PRIMING THE PUMPS
As soon as the Priming Mode screen appears
on the panel, select the “Jets 1” button once to
start Pump 1 in low-speed and then again to
switch to high-speed. Also, select the other
pumps to turn them on. The pumps should be
running in high-speed to facilitate priming. If
the pumps have not primed after 2 minutes,
and water is not flowing from the jets in the
spa, do not allow the pumps to continue to
run. Turn off the pumps and repeat.
Note: Turning the power off and back on again
will initiate a new pump priming session.
Sometimes momentarily turning the pump
off and on will help it to prime. Do not do
this more than 5 times. If the pump(s) will not
prime, shut off the power to the spa and call
for service.
Important:
A pump should not be allowed to
run without priming for more than 2 minutes.
Under NO circumstances should a pump be
allowed to run without priming beyond the
end of the 4-5 minute priming mode. Doing
so may cause damage to the pump and cause
the system to energize the heater and go into
an overheat condition.
EXITING PRIMING MODE
You can manually exit Priming Mode by
navigating to the “Back” button on the Prim-
ing Mode Screen. If you do not manually exit
the priming mode, it will terminate after 4-5
minutes. Once the system has exited Prim-
ing Mode, the top-side panel will display the
Main Screen, but the display will not show the
temperature yet because the system requires
approximately 1 minute of water flowing
through the heater to determine the water
temperature.