MAAX 300 Series, Руководство пользователя

Страница: 37 / 71

37 Owner’s Manual
E
nglish
MODE - REST AND READY
In order for the spa to heat, a pump needs to
circulate water through the heater. The pump
that performs this function is known as the
“heater pump.” The heater pump can be either
a 2-Speed Pump 1 or a circulation pump.
If the heater pump is a 2-Speed Pump 1,
READY
Mode will circulate water every 1/2
hour, using Pump 1 Low, in order to
maintain a constant water temperature,
heat as needed, and refresh the temperature
display. This is known as “polling.”
REST Mode will only allow heating during
programmed filter cycles. Since polling does
not occur, the temperature display
may not show a current temperature until the
heater pump has been running for a minute
or two.
Circulation Mode
If the spa is configured for 24HR circulation,
the heater pump generally runs continuously.
Since the heater pump is always running, the
spa will maintain set temperature and heat as
needed in Ready Mode, without polling.
In Rest Mode, the spa will only heat to set
temperature during programmed filter times,
even though the water is being filtered
constantly when in Circulation Mode.
Ready-in-Rest Mode
READY/REST appears in the display if the
spa is in Rest Mode and Jet 1 is pressed. It is
assumed the spa is being used and will heat
to set temperature. While Pump 1 High can
be turned on and off, Pump 1 Low will run
until set temperature is reached, or 1 hour has
passed. After 1 hour, the System will revert
to Rest Mode. This mode can also be reset by
entering the Mode Menu and changing it.
SHOW & SET TIME-OF-DAY
Setting the time-of-day can be important
for determining filtration times and other
background features. From the main menu,
activate the temperature flashing. While
the temperature is flashing, press “Light”
repeatedly until “TIME” is displayed on the
screen. Proceed to set current time using the
up and down temperature buttons. When
in the TIME menu, SET TIME will flash on the
display if no time-of-day is set in the memory.
24-hour time display can be set under the
PREF menu.
Note: If power is interrupted to the system,
Time-of-Day is not stored. The system will
still operate and all other user settings will
be stored. If filter cycles are required to run
at a particular time of day, resetting the
clock will return the filter times to the actual
programmed periods. When the system starts
up, it defaults to 12:00 Noon, so another way
to get filter times back to normal is to start up
the spa at noon on any given day. SET TIME
will still flash in the TIME Menu until the time is
actually set, but since the spa started at noon,
the filter cycles will run as programmed.
FLIP (INVERT DISPLAY )
From the main screen, activate the
temperature flashing. While the temperature
is flashing, press “Light” repeatedly until
“FLIP” is displayed on the screen. While “FLIP”
is displayed, press either the up or down
temperature button to invert the screen.
Follow the same procedures to flip it back.