VAN DER GRAAF M
K
II
VERY LOW NOISE POWER SUPPLY
REVISION P
R
B – AUGUST 2017
Copyright © 2017, M2Tech Srl
7
M2Tech
www.m2tech.biz
1. Unpacking and Placing the Unit
Lay the package on a table and open the external box removing or cutting the adhesive
tape seal. Then extract the internal box and open it by lifting the front wing. The following
items are included:
one
VAN DER GRAAF M
k
II
;
one power cord;
two output cables with 5.5/2.1mm jacks;
two output cables with 4-pole XLR connectors.
Should one or more item be missing, please contact your retail dealer.
Remove the
VAN DER GRAAF M
k
II
from the box and place it onto a stable base, far from heat
sources. Avoid full sunlight on the unit. Allow for ample room around the unit for venting.
The
VAN DER GRAAF M
k
II
is a power supply capable of delivering up to 50VA when
operating. Even if its regulators are high efficiency ones, and even if not always all outputs
are used, the unit can produce a relevant heat. Therefore, an adequate air flow is
recommended.
Avoid smoke, moisture, dirt and liquids from reaching the unit. Please note that any signs
of abuse will void warranty coverage.
Do not place the unit on thick carpets or inside a box or piece of furniture, not even close
to curtains.
