M2 Antenna Systems RC2800PX-AZ, Руководство по эксплуатации

Страница: 13 / 19

USE THE FOLLOWING INFORMATION TO WRITE YOUR OWN CONTROL SOFTWARE
SUMMARY OF CONTROLLER COMMANDS
Typed commands in lower or upper case, cr = ENTER or carriage return, # = real number including
tenths.
FUNCTION COMMAND DESCRIPTION
SELECT: A or E cr where A = Azimuth, E = Elevation
SPEED:
S# cr where S = 1 (minimum speed) through 9 (maximum)
GO TO:
# cr where # = a number within your programmed parameters. Num-
bers less than 1.0 must be preceded by a 0.#, (0.3)
INCREMENT
+ cr where + = bump + approximately .5 degree
DECREMENT
- cr where - = bump - approximately .5 degree
STOP
S cr where S = stop movement
UPDATE
cr where cr gives one line of Position, Speed, and Movement Status
CALIBRATE CAL NA cr Where ‘cal” starts the positioner moving slowly CCW to
the physical limit switch in the positioner and then automatically resets readout to L346.0.
HOW THE COMMANDS WORK
The RC-2800PX is always in a continuous update mode.
A=135 S=5 M
Meaning: Selected controller (A or E) heading and other status is continually streaming down
the HYPER-TERMINAL screen while positioner is moving. Once (A) azimuth or (E) elevation is
selected, the A or E command is no longer needed. All commands that follow will affect only the
selected positioner.
TO SELECT AZIMUTH OR ELEVATION CONTROL
Type one of the commands below and follow with an ENTER (cr):
-for Azimuth, type: A
-for Elevation, type: E
Once azimuth or elevation is selected, the A or E command is no longer needed. All commands
that follow will affect only the selected positioner.
TO INCREASE OR DECREASE SPEED (assumes A or E has been entered)
Type the command and follow with an ENTER (cr). Speed changes may be entered while positioner is
stopped or moving.
-for minimum speed, type: S1
-for maximum speed, type: S9
Commands S1 through S9 are available. For instance, S4 will set speed to 40% of maximum. Posi-
tioner will return a confirmation with "S=4" and update status at time of command. For example, com-
mand "S8" might return:
E=60.5 S=8 S
Meaning: E (elevation mode), position = 180 degrees, S (speed)=8 (80%), S (stopped)
(or M -moving).
13