Premier 4-6-0 Camelback Steam Locomotive
18
Headlight Replacement Instructions
The locomotive’s lights are controlled by a constant voltage circuit in the engine.
They are easy to remove and replace when they burn out. See the diagrams and
directions below for instructions on accessing and replacing the light bulbs in this
locomotive.
You can obtain replacement bulbs directly from the M.T.H. Parts Department
(Order online: www.mth-railking.com, e-mail: [email protected],Fax: 410-
423-0009, Phone: 410-381-2500, Mail: 7020 Columbia Gateway Drive, Columbia
MD 21046-1532, ).
To Replace Headlight:
1. Remove the body mount screws as shown on (Page 14) and separate the boiler
from the chassis.
2. Remove the screw at the bottom of the smokebox to release the smokebox
front.
3. Gently pull the headlight bulb from the rear of the headlight shell.
4. Unplug the headlight light connector (blue) from the wires harness in the boiler
shell.
5. Install the new bulb by reversing the order of the steps above.
6. Place the boiler back on the chassis. Make sure that no wires are pinched. Then
replace the body mount screws.
Remove Screw to access headlight
headlight
