R6S-DA4
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
EM-7781-BC Rev.3 P. 4 / 4
• How to Connect Wires
Screwdriver
Wire
1) Insert a minus screwdriver into the wire entry opening,
between the clamp and the housing, until its tip hits the
bottom where it is firmly held.
Tension Clamp
Screwdriver
2) Insert a wire. Push the screwdriver toward the direction
indicated with the arrow in the figure below to widen the
opening if necessary.
Wire Entry
Wire
3) Confirm that the wire tip hits the bottom and pull out the
screwdriver in holding it in position.
Confirm that the wire’s insulation tube is not caught in
the clamp.
PC CONFIGURATOR
With configurator software, settings shown below are available.
Refer to the software manual of R6CON for detailed operation.
■
CHANNEL BATCH SETTING
PARAMETER
AVAILABLE RANGE
DEFAULT SETTING
Loss of internal bus communication detection time 0.0 – 99.9 (sec.)
1.0 (sec.)
Sampling cycle
1, 5, 10, 20, 50, 70, 100, 200 (msec.)
10 (msec.)
