M2EXM
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected]
EM-5135-B Rev.5 P. 3 / 19
INSTALLATION
Loosen the fixing screw in front of the unit in order to separate the body from the base socket.
■
FIXING SCREW
The fixing screw can be pushed into the body when it is not
in use. Tighten the knob until the body is securely attached
to the base socket. Push it into the body and turn it clock-
wise to lock. Push the knob and turn it counterclockwise to
unlock so that the knob pops out.
■
DIN Rail
35mm wide
Spring Loaded
DIN Rail Adaptor
DIN RAIL MOUNTING
Set the base socket so that
its DIN rail adaptor is at
the bottom. Position the
upper hook at the rear side
of base socket on the DIN
rail and push in the lower.
When removing the socket,
push down the DIN rail
adaptor utilizing a minus
screwdriver and pull.
■
WALL MOUNTING
Refer to “EXTERNAL DIMENSIONS.”
TERMINAL CONNECTIONS
Connect the unit as in the diagram below or refer to the connection diagram on the side of the unit.
■
EXTERNAL DIMENSIONS unit: mm (inch)
29 (1.14)
83 (3.27)
94 (3.70)
8
(.31)
124 (4.88)
22 (.87)
6 (.23)
59 (2.32)
11–M3
SCREW
72 (2.83)
36 (1.42)
29.5 (1.16)
2–4.2x5
(.17x.20)
MTG HOLE
6 (.24) deep
DIN RAIL
35mm wide
[4 (.16)]
• When mounting, no extra space is needed between units.
4
8 7
10
8
(.31)
11
5
6
1
2
3
9
■
CONNECTION DIAGRAM
+
–
U(
+
)
V(
–
)
1
4
2
CONFIGURATOR
JACK
7
8
OUTPUT
10
11
POWER
+
–
3
2
1
POTENTIOMETER
max.
min.
