M-E Vista Door System VDV-503, Руководство по эксплуатации

Страница: 11 / 28

GB
ENGLISH | VDV-503
11
OPERATION
Ringing the external unit sounds the bell tone on the internal unit, and
the visitor is displayed on the monitor. Press the voice button (4) to
establish voice communication. Having spoken to the visitor, you can
open the door (if a door opener is linked) by pressing the door opener
button (3) or end the conversation by pressing the voice button again.
This returns the internal unit to standby mode.
If multiple external units and/or additional cameras are linked, you can
switch to the other external units/additional cameras by pressing the
monitor button (2). This can be done at any time, even if the bell has
not been rung.
Voice communication is not possible while the image from an additional
camera is active.
Pressing the voice button twice returns the internal unit to standby
mode. If a button is not pressed, the monitor switches off automatically
after approximately 60 seconds.
SYSTEM FUNCTIONS
Ringing
If the bell push on the external unit is pressed, the internal unit emits
the bell tone that has been set, and the luminous surrounds of the
voice button and door opener button on the internal unit flash for
approximately 60 seconds. The monitor is also activated during this
time and the image from the external camera can be seen.
Voice communication
Press the voice button once. The luminous surround of the voice button
lights up blue while voice communication is active.
To terminate voice communication, press the voice button again. You
can re-establish voice communication at any time. The bell does not
need to be rung first. Simply press the voice button again.
Door opening
A linked door opener is activated for approximately 6 seconds or 1
second by briefly pressing the door opener button (see instructions for
the external unit used). You do not have to hold the door opener button
down. Confirmation is provided by a double beep sound at the external
and internal unit, and the name tag lights up green for the time the
door opener is activated.
The door opener can be activated if:
1. The bell has been rung (without having to establish voice communi-
cation first, within 60 seconds).
2. The reply function is active.
OSD settings
The following settings are made via the On-Screen Display (OSD). To
access the OSD, briefly press the menu button (12) on the indoor unit.
Each time you press the Menu button briefly, it moves to the next menu
item. The plus and minus keys can be used to adjust the respective
value. The values are saved automatically. The OSD switches itself off
automatically 6 seconds after the last key press.
Brightness
Contrast
Colour saturation
Voice volume
Ringtone
Ringtone volume
Melody of the VTX-Bell (only for VTX-Bell with 4-pin connector)
Own melody on memory card
This intercom system offers the possibility to select your own ringtones,
which can be stored in MP3 or WAV format on a micro SD card. The
memory card must be formatted with
FAT32 . You store your ringtones
directly on the SD card (without using folders), a maximum of 16 diffe-
rent ringtones can be stored on the SD card. Insert the SD card prepared
in this way into the SD card slot (20) on the board. The ringtones on
the memory card replace the internal ringtones. When the memory card
is removed, the internal melodies are available again.
Deactivating the bell tone (e.g. if night-time quiet is required)
The bell tone can be deactivated. To do this, press the sleep button (6)
of the internal unit once briefly. The LED (5) lights up red to remind
you that the tone is deactivated. To reactivate the bell tone, press the
sleep button briefly again. The LED will go out and the bell tone is
reactivated.
The optical signal (luminous surrounds of the voice and door opener
button) remains active even when the bell tone is deactivated and will
continue to indicate the bell being rung.