M-E VDV-807, Руководство по эксплуатации

Страница: 18 / 48

GB GB
GB
ENGLISH | VDV-807
VDV-807 | ENGLISH
18 18
VDV-807 indoor unit for video door phone system
Thank you for purchasing this video internal unit. It can be
combined with all components from the VISTADOOR and
VISTUS systems. When the linked external unit is rung, the
internal unit plays the set bell tone and the visitor can be
seen on the monitor. You can then speak with the visitor and
also open the door (provided a door opener is linked).
CONTENTS
Internal unit with 17.8 cm (7”) screen size
Fixings
Operating and installation instructions
Drilling template
Key
1 = Microphone
2 = Monitor button
3 = Door opener button
4 = Voice button
6 = Sleep button
8 = Voice volume adjuster
9 = Bell tone button
10 = Alarm/intercom button
11 = Minus button
12 = Plus button
13 = Menu button
15 = Slot for micro SD card
16 = Housing screws
INSTALLATION (Fig. 2a+b)
1. Identify a suitable place to fit the internal unit and lay all
the cables needed to this point.
2. Remove the two screws (16) from the internal unit and
lift the front cover off the unit.
3. There are two attachment clips at the centre of the sides
of the internal unit. Carefully pull off the front cover.
4. For cable entry into the housing, the latter has a hole in
it at the top below the connection terminals.
5. Use a spirit level to correctly align the supplied drilling
template at the point on the wall where the internal unit
is to be fitted. Alternatively, the back of the internal unit
housing can be used to mark the drill holes.
6. Fix the drilling template in position with adhesive tape
and drill the four marked holes (Ø 6 mm).
7. Take the drilling template off and insert one of the plugs
supplied in each of the holes.
8. Feed the connecting cable through the hole in the bot-
tom of the internal unit housing and screw the housing
to the wall using the four screws.
9. Connect the cables as shown in the wiring
diagram (Fig. 4).
NOTE : Do not cut the cables too short. There are clips in
the bottom of the housing that the cable can be wound
around.
10. Attach the front cover with the monitor. Make sure that
the attachment clips engage properly.
VDV-807_I-Manual_170x170 Fin1.indd 18 11.12.20 21:17