M-E ODYON pro WE10/230, Инструкция по эксплуатации

Страница: 23 / 32

taught-in to another receiver.
The wall receiver can thus also be used to create a stationary 2-channel transmit-
ter.
The buttons must not be operated at the same time.
Once everything has been connected and checked, the power supply can be
established.
Operating Mode Switching Contact / Teaching Hand-held Transmitter
The switching contact offers 3 different operating modes in order to be able to
use it as versatilely as possible.
2-Channel" operating mode
Slide the selector switch for the operating mode to the "2-Channel" position
according to the labelling on the circuit board.
Press the button for channel 1 (5), the red and green LEDs of channel 1 now light
up. Then press two buttons on the hand-held transmitter in succession, e.g.
button 1 and button 2. The red and green LEDs each flash once to confirm and
then go out.
Now the switch contact is switched ON when the first key (1 in the example) on
the hand-held transmitter is pressed and switched OFF when the second key (2 in
the example) on the hand-held transmitter is pressed. The orange LED of channel
1 lights up when the relay is switched ON.
Toggle" operating mode
Slide the operating mode selector switch to the "Toggle" position.
Press the button for channel 1 (5), the channel 1 LEDs light up red and green, and
then press the desired button on the hand-held transmitter. The red and green
LEDs flash once for confirmation and then go out.
Now the contact switches every time the corresponding button on the hand-held
transmitter is pressed. The orange LED of channel 1 lights up when the relay is
switched ON.
EN
23