M Design DIAMOND Gas 550V, Инструкция по установке и эксплуатации, Страница: 14 / 43

14
B
A
min. 5 mm
Instructions for installation and use DIAMOND Gas 550V-DV-850V-DV-1150V
6. Insulation and finishing
Once installation is complete, the appliance can be fitted. Before doing so, check the
tightness of the gas pipe one more time. Light the appliance and check that it is wor-
king: check the tightness of the gas pipe and the smoke pipe. Once you have checked
everything, you can perform the final insulating and finishing operations.
The built-in part of the appliance tends to be very warm. Please check that the ap-
pliance is not too narrowly fitted and that there is adequate space for the elimination
of hot air. For insulation of the appliance, we advise you to use M Design insulating
plates. You are advised against using any other insulation product. Inflammable mate-
rials as well may not be used for the finishing.
Please , follow this instruction. The appliance can overheat if you do not
follow these instructions. Errorcode F02 will appear !
Masonry must be raised around the fireplace. Due to the expansion
of the fireplace during combustion, a gap of at least 5 mm must be
provided at the front of the fireplace and 4 cm on each side of the
appliance. The masonry must not rest on the fireplace. THE FIRE-
PLACE MUST BE FREE. Always leave 2 mm clearance between the
inner frame and the masonry.
A very essential point when setting up the Luna
Gold is that the distance has to be respected
inbetween fireplace and the finishing material for
the mantlepiece such as marble, gipsum,...
For this, a small bended metal sheet that is provi-
ded on the fireplace ( pic.1 ) , is to be used as the
minimal reference for the distance. The finishing
can only go as far as this metal sheet (pic.2 ).
Don’t remove this ( pic.3 ) ! This allows you to
take out the 4th side frame and to let the airflow
in the mantelpiece for natural convection
Pic1
Pic2
Pic3
Air inlet
Flame setting
B
A
Adjustable air diffusion for flame setting
Air inlet
Flame setting
Adjustable air diffusion for flame setting