4.2 Rear Panel
1.
9v AC Power Jack: This jack accepts a 2.5mm plug from a 9vAC, 500 mA
power supply, included with the Omni. Use only the proper, AC power
supply on the Omni.
2.
Direct Outs 1 – 4: These jacks are connected to the Delta H/W Outs 1
through 4, and bypass the Omni mixer. The 1/4” jacks accept TS plugs for
unbalanced operation, or TRS for balanced.
3.
Phantom Switch: When pressed and locked to the in position, phantom
power is engaged and is sent to the XLR microphone inputs. Phantom
power is switched off when this button is in the out position.
4.
L&R Record (Mix) Outs: The 1/4” jacks accept TS plugs for unbalanced
operation or TRS for balanced. The “Record (Mix) Outs” typically feed a
stereo mixdown deck. These outputs are pre-Monitor Control level, and are
therefore unaffected by changes in “Monitor Control” position.
5.
FX Send: This mono send accepts a TS plug for unbalanced operation, or
TRS for balanced. The send gets its signal from the position of the “Channel
1-4 Effects Send” controls in relation to the signal present at the Delta H/W
Outs 1-4.
6.
L&R Monitor Outs: The 1/4” jacks accept TS plugs for unbalanced operation
or TRS for balanced. These outputs typically feed a monitoring system. They
receive their signal from the stereo bus of the Omni mixer post-Monitor
Level control, and are therefore directly affected by the position of the
“Monitor Control.”
7.
Stereo Aux Ins 1 – 4: These 1/4” jacks accept a TRS plug that is designed to
carry the L&R signals from a stereo source, such as a MIDI keyboard or
other stereo instrument. Typically, a stereo cable with a TRS plug to L&R
mono TS plugs, often called an “insert cable,” will work properly.
8.
“To Ins 1, 2” Switch: This switch, when pressed and locked to the
in
position,
will send the stereo signal that is present at the Aux In 1 jack to the Delta
H/W In 1 & 2. The Aux In 1 signal is then simultaneously muted to the
Omni stereo buss.
6
1
2
3
4
5
7
6
8
9
10
11
12
13
7
