7
6.
By adjusting the
Compressor Attack Control
, you can adjust how fast the signal
compresses
(reduces to the setting of the
Compressor Ratio Control)
after the signal
exceeds the threshold setting of the Compressor.
The fully counterclockwise position
yields the fastest "attack," and the fully clockwise position yields the slowest "attack."
7. By adjusting the
Compressor Release Control
, you can adjust how fast the signal
increases from the setting of the
Compressor Ratio Control,
after the signal falls below
the threshold setting of the Compressor.
The fully counterclockwise position yields the
fastest "release," and the fully clockwise position yields the slowest "release."
1.2.2.3
Working with Custom Effects:
Each channel of NRV10 interFX allows you to load up to two custom, or user-defined,
VST effects.
The
User Effect Slots
are located beneath the Compressor of each channel.
Both
User Effect Slots
function in the same manner, so we'll cover only the first
User Effect Slot
in this tutorial.
To load a VST effect to
User Effect 1
, follow these steps:
1. Click the
User Effect 1 Plug-in Chooser
of channel 1, and select the desired plug-in.
2. To open the editor window of the effect, click the
User Effect 1 Edit Button
.
3. To bypass
User Effect 1
, click the
User Effect 1 Bypass Button
.
4. To remove the effect, click the
User Effect 1 Plug-in Chooser
, and select "Remove
Plug-in" from the resultant menu.
Note: If NRV10 interFX does not show plug-ins that you known are installed on your
system, refer to the Troubleshooting section of this guide.
1.2.2.4
Setting Optimal Output Gain:
Located at the bottom of each NRV10 interFX channel, you'll find a
Gain Control
and a
Level Meter
.
The
Gain Control
raises or lowers the output of the NRV10 interFX channel
to the NRV10 Mixer, where the 12 o'clock position equals no gain change.
Depending
on the Expander-Gate, Compressor, and custom effect settings of a channel, you may
need to alter the
Gain Control
.
While adjusting the
Gain Control
, observe the
Level Meter
.
If the uppermost LED lights up (the red LED), move the
Gain Control
counterclockwise to reduce the signal's loudness, and thus prevent distortion.
It is also
good practice to "boost" the signal as much as possible, without creating distortion.
To
increase or "boost" the loudness of the signal, move the
Gain Control
clockwise.
Содержание NRV10
Страница 1: ...1 NRV10 InterFX User Guide Version 1 0...
