mode, the left channel of the S/PDIF In is routed to OUT4 and the right
channel of the S/PDIF In is routed to OUT3.
4. Options four through seven connect the hardware analog inputs 1 & 2, 3 & 4, 5 &
6, or 7 & 8 (respectively) directly to the 1010LT’s hardware analog outputs 3 & 4.
For example, if "H/W In 1/2" were selected, any signal present at the IN1 port
will be copied to OUT3, and any signal present at the IN2 port will be copied to
OUT4. This same behavior applies to "H/W In 3/4," "H/W In 5/6," and "H/W
In 7/8" when selected.
The rightmost vertical column of Patchbay/Router page, "H/W Out S/PDIF," connects the
Delta 1010LT’s hardware S/PDIF outputs to one of eight sources:
1. The default setting, "WavOut S/PDIF," connects the S/PDIF Out port to your
music software or Windows multimedia applet. In other words, when music
software plays audio to the device named "WavOut S/PDIF Delta-1010LT" it
will be routed directly to the hardware S/PDIF output on your Delta 1010LT
PCI host card.
2. The second option, "Monitor Mixer," connects the S/PDIF Out port to the
outputs of the Delta 1010LT monitor mixer. For more information on the
capabilities of the monitor mixer, please see the section "Monitor Mixer Page."
3. The third option, "S/PDIF In," connects the S/PDIF Out port directly to the
hardware S/PDIF input on the Delta 1010LT PCI host card. The left channel
of the S/PDIF In is routed to the left channel of S/PDIF Out and the right
channel of the S/PDIF In is routed to the right channel of S/PDIF Out.
4. The fourth option, "S/PDIF In (L/R Rev.)," functions identically to the third
option, except that the left and right channels are swapped. Therefore in this
mode, the left channel of the S/PDIF In is routed to the right channel of
S/PDIF Out and the right channel of the S/PDIF In is routed to the left
channel of S/PDIF Out.
5. Selections five through eight connect the hardware analog inputs 1 & 2, 3 & 4,
5 & 6, or 7 & 8 (respectively) directly to the 1010LT’s S/PDIF Out port. For
example, if "H/W In 1/2" were selected, any signal present at the IN1 port will
be sent to the left channel of the S/PDIF Out, and any signal present at the IN2
port will be sent to the right channel of the S/PDIF Out. This same behavior
applies to "H/W In 3/4," "H/W In 5/6," and "H/W In 7/8" when selected.
At this point, you may begin to realize the versatility of the Monitor Mixer and the
Patchbay/Router, and the relationship between the two. You may want to re-read this section
and make some practice adjustments within the Delta Control Panel software to become
proficient in routing and mixing, as well as check out the Tutorials section toward the end of
this manual. If somewhere in the process you become confused, you may always restore the
default settings to use the card as a straight 10-in 10-out device -- just choose the topmost
option in each of the Patchbay/Router columns.
Hardware Settings Page
The Hardware Settings page of the Delta Control Panel gives you control over
miscellaneous features of the Delta 1010LT. To display this page, click the "Hardware
Settings" tab of the Delta Control Panel.
23
