M/A-Com Orion, Руководство по установке

Страница: 41 / 80

b. Using the machine screws and flat washers provided with the handle
assembly, attach the handle to the bottom of the radio. The two holes
on the handle should align with the two holes on the radio created by
step (A). Once installed, the rubber handle should rotate freely from
over top of the radio to just out in front of the control unit
(approximately 90 degrees). Be sure to torque the two mounting
screws within 6.5 to 8.25 in/lb limits.
5. Connect the antenna coaxial cable to the cassette mounting assembly rear
connector.
6. Connect the power leads and the ignition sense leads as described in
previous sections. See Figure 38.
7. Connect the speaker cable connector P2 to the speaker and the basic
accessory connector P3 to the following options (if used, see Figure 38.)
OPTION PLUG AND PIN
Ext. Hookswitch P3-3 (HOT)
P3-6 (GND)
Foot Switch P3-5 (HOT)
P3-2 (GND)
Horn Relay P3-1 (HOT)
P3-4 (GND)
8. Connect the extended option accessory plug P4 to the following options
(if used, see Figure 36.)
•
Mobile Data Terminal
•
Public Address (External Amplifier)
•
External Microphone
•
External Tone Encoder
•
External Tone Decoder
•
Output (User Defined)
•
Input (User Defined)
CAUTION
Refer to accessory manual supplement for details regarding
the extended options listed above. DO NOT CONNECT
DIRECTLY TO A PC OR DATA TERMINAL. DAMAGE
COULD RESULT!
41