Beehive scale GBS-1 Classic use – manual.
The scale consists of a table with movable desktop attached to the tensometric sensor
using a controller with a display and GSM communications module, and the
powering battery module.
1.
Preparing the scale to work.
The scale will be ready to work when all the elements included will be connected.
The next steps should be completed accordingly:
•
Using a screwdriver, unscrew four screws that secure the controller case's lid,
after that, take off the lid.
•
The controllers' electronic board is attached to the lid and on that board there is
a spot signed as SIM which is a slot to insert a SIM card. The card is supposed
to be inserted into that slot.
ATTENTION: The SIM card should be prepared to work before. In order to do that,
one must register the card in a manner that is determined by the provider and then
you need to activate the card inside an external device such as mobile phone in a
manner determined by the provider.
The first activation the provider sends a special sms informing the client about the
activation status and enabled services. Before inserting the card to the scale, all
messages should be deleted. In a later time, if one must activate additional services,
you will use the external device such as phone to do that and then delete the
messages.
The SIM card cannot have protection other than PIN number. In case the SIM card is
blocked and you need to use the PUK number provided by the operator using the
same external device.
•
A battery sustaining the local clock should be inserted to the socket CR2032.
•
Check the correctness of the mounted GSM antenna.
•
Put the controller's lid onto the case and screw the screws which mount the lid.
•
The taken cable with 5-bolt plug from the scale's table, plug it into the socket
that is located on the left side of the controller's case and tighten the top cap
that secures the socket.
•
To the 3-bolt socket plug the hive's temperature sensor in.
•
At this moment, you can turn the scale on using a gray cable with the 2-bolt
plug with a socket in the battery module. The controller's display should spark
a light with a text showing the software version and the controller's serial
number.
WARNING: In case the battery's voltage is detected too low, the scale will notify the
user using the display and will turn off. The proper battery must be plugged in.