PEC 1864 Reference Manual - Rev 1.2
© 2017
LYNX
Technik
AG
Page 28 of 41
Logo Insertion
The PEC 1864 includes a logo inserter. The logo is inserted before the encoders i.e. when
inserted, the logo will be on both outputs in the same position.
Use the "Image File" button to select and upload the logo file.
It's only possible to upload one logo file i.e. uploading a new file will replace the existing
one.
The logo image is not resized. Therefore, the same logo file will be bigger or smaller for
different input resolutions. The image needs to comply with the following specifications:
•
Supported formats are JPG, BMP, GIF, PNG
•
Only PNG and GIF support transparency
•
The filename needs to be lower case letters (no caps, spaces or special characters)
and can be a maximum of 20 characters long
•
The file has a maximum of 16 colors
•
The width of the image needs to be divisible by four
•
The image must not exceed 16,.000 pixels when calculated with the following
formula:
o
(width + 12) * 24 ≤ 16,000
Once the logo has been uploaded the following controls are available:
•
Insert Logo (On, Off) [Default = Off)
•
X-Position (0 to max. horizontal resolution of detected video input) [Default = 0]
•
Y-Position (0 to max. vertical resolution of detected video input) [Default = 0]
Note:
The positioning of the logo is based on the top left corner of the logo image. The origin of the
X/Y positioning is the top left corner of the video signal. In other words, when X and Y position is set
to "0" the logo will be in the top left corner.
Note:
When a logo has been uploaded to the PEC 1864, the window on the right side of the Web UI
will show a preview of the logo.
