2 Part # 33807 Rev 2016
Upon opening the box and identifying the components you will need 3 parts to begin assembly. You will need
the back panel and the two side panels (L & R). Please note that you will need to have these parts upside
down. On the side panels, there are some rivets attached to them. Those rivets will line up with the slots on the
side of the back panel. You will need to push down the panel to lock it in place. Once you attach the side panels
with the back panel make sure the whole frame is flush to the top.
Step 1.
Back Panel
Le
ft
Pa
n
el
R
ig
ht
Pa
ne
l
Step 2
While the cart is upside down, locate the 4 #8 screws
and nuts. You will use these screws and nuts to attach
the transformer to the access plate. Make sure when
attaching the transformer to the access plate the cord
is facing up. You can also attach the transformer to
the access plate upon the full assembly completion of
the cart.
Step 1: All Panels (Pictured Upside Down)
Flush Panels
Rivet and Slot
Step 2: Transformer attached (Pictured Upside Down)
Step 3
To attach the base of the cart you will need to space
out the side panels on the cart enough to slide in
the base. Make sure when you attach the base to
the panels that the tank holder is on the left hand
side of the frame while upside down.
Tank
Hole Side
Step 3: Space out the Panels Here
