Lynx LBCDW2, Инструкция по использованию и установке

Страница: 5 / 36

5
10. BACK PANEL INSTALLATION
• Remove all protective covering from panel and install using the 10 x 1/2” tek screws provided. (See Illustration #8).
• Attach rear toe kick to legs. (See illustration #8).
NOTE: For end of the run panels, the rear, front, and side toe kicks must be modifi ed. (See illustrations #7 & #8)
11. INSTALL LOCALLY SUPPLIED COUNTERTOP
All outdoor cabinets must be installed with a locally supplied
non-
combustible counterop. The cabinets are designed for a minimum
countertop thickness of 1 1/8” (2.9 cm) such as you would fi nd with
granite or quartz material. If a countertop material thicker than 1 1/2”
(3.8 cm) is used, the appliances should be shimmed to the proper
height.
12. Refer to appliance installation instructions for specifi cations, minimum
clearances and warnings.
INSTALLATION
1. Place rear panel into area of the
cabinet.
2. Attach from inside
with (4) tek screws
provided.
(front and rear)
Rear toe kick (C)
Illustration #8
3. After modifying rear toe kick (See dimension
chart at the bottom of page 4) - snap toe kick
into place
1-1/8”
(2.9 cm)
Min
Illustration #9