Lynx L15ICE, Руководство пользователя и инструкции по установке

Страница: 17 / 23

Lynx L15ICE 17
23) Disconnect the suction tube by
compressing both plastic tabs to unlock the
joint in the direction of the black arrows and pulling the
tube clear.
24) Spread out the tabs on both sides of the water
tank to unlock it, then pull it out toward you. Drain
the tank.
25) After draining, slide in the water tank along the
rails at the bottom of the right and left brackets until it
clicks into place.
26) Refit the suction tube onto the water tank inlet by pushing
the joint to lock it securely in the direction of the arrows. A
loose fitting may cause a water leak.
27) Repeat 20) through 26) one time.
28) Open the water supply line shut-off valve.
29) Move the control switch to the "WASH" position
to circulate clean water for about 5 minutes.
30) Move the control switch to the “OFF" position, then remove
the water tank, drain it, a replace it as described in 23)
through 26).
31) Repeat 29) and 30) two more times to rinse thoroughly.
32) Move the control switch to the "ICE" position, and start the
automatic ice making process.
20) Mix a new batch of the sanitizing solution and slowly pour it into the water tank.
21) Move the control switch to the "WASH" position.
22) After circulating the sanitizing solution for about 15 minutes, move the control switch the "OFF" posi-
tion.
Cleaning and Care Procedures
L15ICE