Lynx L15ICE, Руководство пользователя и инструкции по установке

Страница: 14 / 23

Lynx L15ICE 14
12) Move the control switch to the "WASH" position to circulate clean water for about 5 minutes.
13) Move the control switch to the "OFF" position, then remove the water tank, drain it, and replace it as described
in 3) through 6).
14) Repeat 12) and 13) three more times to rinse thoroughly.
Sanitizing Solution
Dilute 0.5 fl. oz. (14.8 ml or 1 tbs) of 5.25% sodium hypochlorite solution (chlorine
bleach) with 1 gallon (3.8 l) of warm water. Using a chlorine test strip or other method,
confirm that you have a concentration of about 200 ppm.
Sanitizing Procedure
The sanitizing process will sanitize the icemaker.
1) Move the control switch to the "OFF" position.
2) Open the bin door and remove ice from the
storage bin.
3) Remove the slope by bending its center
carefully and releasing it from the two slope
shafts. Remove the slope from the storage bin.
4) Thoroughly clean and sanitize the storage
bin, slope, scoop and any parts normally
accessible from the storage bin.
5)
Remove each separator by lifting it to the
horizontal position and pushing it hard
inward. Remove all separators in the same
way and clean and sanitize them.
6)
Disconnect the suction tube by
compressing both plastic tabs to unlock the
joint in the direction of the black arrows and
pulling the tube clear to drain the tank.
IMPORTANT
For safety and maximum effectiveness, use the solution immediately after dilution.
Cleaning and Care Procedures
L15ICE