Lynx AES16, Руководство пользователя

Страница: 63 / 82

Using the AES16
AES16 User Manual 63
7.3 Monitoring
Low latency monitoring can be enabled using
the AES16’s on-board digital mixer. This
method avoids delays caused be monitoring
through applicaton software. The digital mixer
can be setup manually using the Lynx Mixer
application or within applications that support
direct monitoring.
As discussed in Section 5, each ouput of the
AES16 is derived from a four-input submixer.
This submixer is shown below. The inputs to
the submixers include both input signals and
playback signals. Enabling record monitoring
is simply a matter of selecting a desired input
signal for mixing on a particular ouput.
Output Bus
(16 signals)
Monitor
Select
Monitor
Select
Monitor
Select
Monitor
Select
Master
Fader
SUM Dither
Peak
Level
Meter
Digital Mixer Ouput Submixer
( 1 of 16 )
Record Bus
from Inputs
(16 signals)
Play Bus
from Play devices
(16 signals)
Manual setup using Lynx Mixer
The Outputs page of the Lynx Mixer provides
access to the submixer connected to each
physical output. Controls on this page allow
manual setup of monitoring.
The four Monitor Select blocks shown in the
submixer diagram correspond to the four
Output Monitor Source buttons above the
faders on each output channel of the Lynx
Mixer. A mouse click on one of these buttons
launches a menu of Record and Playback
sources. Selecting a Record source cause in
input signal to be routed to the output.
Horizontal faders below these buttons
correspond to the submixer input volume
controls, , shown in the diagram.
In this example, Digital In 1 is
being selected as a monitor source
for Output 1 Left. The “M” button
next to the Output Monitor Source
button must be in the “out”
position to unmute a monitor
source. After the source is selected,
a corresponding four-letter
pneumonic will appear on the
button.