Lyngdorf TDAI-3400, Руководство пользователя

Страница: 37 / 47

37
General Setup
Power management
Standby level
Network Standby will allow control systems to activate the TDAI-3400 through the network. Deep Sleep
brings the power consumption at stand-by to the required minimum, thus causing some delay in activation of
the amplifier.
Auto off delay
If you don
’t press any buttons or audio isn´t being played, this sets the idle time required for automatic shut-
down of the amplifier.
Trigger input function
The trigger input can be used to activate the TDAI-3400 from a source.
The available settings are
“Amp Power Mode” or a specific input.
“Amp Power Mode” will start the TDAI-3400 on the input last used.
Always select specific input.
Note:
If the TDAI-3400 has been switched to another input, the trigger command from the
source connected will NOT turn off the amplifier.
Display settings
•
Brightness level: Set the brightness of the display.
•
Enable timeout: If enabled, the main display will switch off after 10 seconds of inactivity.
Password
Lock the menu system to avoid unintentional changes.
Unlock the menu system by entering the code 7800 . When the code has been entered, and you exit the
setup menus, the menu lock will reactivate automatically after 5 minutes.
Remote control
Activate or deactivate the remote control. This function is useful if you are using a home automation system
and other remotes are using the same IR codes as the TDAI-3400 remote.